the usual type of fiber optic protection sleeve is 40mm,50mm and 60mm heat shrinkable sleeve for single fiber and 6 cores,12 cores fiber optic protection sleeve for ribbon fiber cable.
Ribbon Fiber Fiber Optic Protection Sleeve 6cores 12cores is applied to the optical fiber closure to fix and protect the optical fiber when splicing.The sleeve can be divided into two types (single sleeve and ribbon sleeve) according to the function.
The single type is used for the single-fiber, and the mass type is used for the ribbon fiber. It is different in the reinforcement between two types. The single one realizes the reinforcement by the stainless steel needles, the later one via the ceramic reinforcement member to realize the function.
Ribbon sleeve means there are several cores for the fiber. So the mass sleeve includes 4cores, 6cores, 8cores, 12 cores (for types).
Single holed (pre-shrunk)
Clear sleeve design
Smooth stainless steel reinforcing member
Sealing structure suitable to temperature
Extended liner length
Low shrink temperature
Pre installed stainless steel or ceramic rod
Accommodates single or ribbon fibers
Wide range of sizes
Operating temperature -45degree to 100degree
Min. full recovery temp: 120degree
Fiber cable protecting
|Properties||Test Method||Typical Data|
|Tensile Strength（MPa)||ASTM D2671||18|
|Ultimate Elongation (％)||ASTM D2671||700|
|Dielectric Strength(KV/mm)||IEC 243||20|
|Dielectric Constant||IEC 243||2.5|
|Longitudinal Change (％)||ASTM D2671||5|
|Operating Temperature (℃)||-55～+60|
|Shrinking Temperature Range (℃)||+90～+110|
Pakaging and logistic: